如何有效地清除打印支撐架


A. Removing the Support 拆除支撐

  1. Use pliers to remove the support structure from your print. 使用鉗子從打印件中取出支撐結構。
  2. Use scalpel to remove the remaining support from your model. 使用解剖刀從模型中刪除剩餘的支持。

residue_1_1a-825x550

residue_1_2a-825x550

B. Smoothing Down the Surface 平滑表面

If the residues are difficult to remove, use a grinder to smooth down the surface. 如果殘留物難以去除,請使用研磨機平滑表面。

residue_3_1b-825x550 residue_3_1a-825x550

C. Removing the Support part 2 拆除支撐第二部份

If there are any holes in your print, remove the support from them using a drill or a drill-driver. 如果打印件中有任何孔,請使用鑽孔器或鑽孔驅動器從其中取出支撐件。

residue_4_1b-825x550 residue_4_1a-825x550

D. Polishing the Surface 拋光表面

Smooth down the surface of your print with sandpaper. Use sandpaper with 80 grit to even all the imperfections. Use sandpaper with 160 grit to make sanding lines less visible. 用砂紙平滑打印的表面。 使用80粒度的砂紙,甚至所有的瑕疵。 使用160粒度的砂紙,使砂光線不太明顯。

residue_5_1a-825x550 residue_5_1b-825x550